2015 + Mustang 750 HP JDM/Roush Phase 2 Upgrade Kit
Are you looking to tear up the streets or drag strip with your 2015 + Roush Supercharged Mustang ?
Do you feel like your car is not at its full potential or has more to offer ?
Then look into our JDM/Roush Stage 2 Kit. Our kit comes with a smaller supercharger pulley to increase boost levels, a set of colder degree spark plugs to protect against spark blowout and detonation, a Roush boost a pump to keep fuel levels safe and a VMP secondary air intake temp sensor to monitor Post Intercooler Temperatures.
All of this paired with our SCT Tune will push your Roush charged Mustang to the limits !
**** see our drop down box for recommended upgrades for this kit ****
2015+ Mustang 750 HP JDM/Roush Phase 2 upgrade Benefits:
- Increase boost
- Increase fuel levels
- Increase HP
- Better drivability
- 750 HP
- 630 ftlb torque
2015+ Mustang 750 HP JDM/Roush Phase 2 upgrade Includes:
- VMP Boost A Pump
- 79mm Pulley
- Ford Performance 0 degree
- SCT X4 with JDM Custom Tune
- VMP IAT Wiring Kit #15IATKIT
2015+ Mustang 750 HP JDM/Roush Phase 2 upgrade Fits :
- 2015 Mustang GT
- 2016 Mustang GT
- 2017 Mustang GT
Important parts and tuning notice:
By ordering this tune, you agree to assume all responsibility for assuring that it is to be used for off-road and/or competition use only and is not to be used on a vehicle that is registered for use on public roads nor highways.
IT IS OUR POLICY TO NOT DISABLE ANY FEDERALLY MANDATED EMISSIONS EQUIPMENT NOR MONITORS ON ANY VEHICLE WITH A VEHICLE IDENTIFICATION NUMBER (VIN). IT IS A FEDERAL OFFENSE FOR US TO DO SO.
Because U.S., Canadian, and other international, state or provincial laws and regulations may prohibit removal or modification of components that were installed on vehicles by Ford Motor Company to meet emission requirements or to comply with motor vehicle safety regulations applicable to vehicles manufactured for use on public roads, JDM Engineering wants you to know the following:
Most of the parts and services offered in this online catalog are for off-road use or competition use only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this off-road or race use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assume all associated risk of the purchase.
Emissions Notice:
Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. JDM Engineering assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer's modifications and/or use of our products or services. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
California Residents
The emissions laws and regulations of the state of California apply to all non-racing vehicles. Consequently, some parts in this catalog may legally be used in California only on a racing vehicle which will never be operated on public roads.
